Difference between revisions of "Bright:DNS"
Jump to navigation
Jump to search
(Created page with "== Add a new nameserver using the GUI == You may need to use another nameserver on the headnode - in bostons case this is to use the DNS for PXE Normally you would simply ch...") |
(No difference)
|
Revision as of 15:58, 8 January 2014
Add a new nameserver using the GUI
You may need to use another nameserver on the headnode - in bostons case this is to use the DNS for PXE
Normally you would simply change the resolv.conf file. If you look at the file you will see that its auto generated by bright. The settings should be defined and changed through bright.
# This section of this file was automatically generated by cmd. Do not edit manually!
# BEGIN AUTOGENERATED SECTION -- DO NOT REMOVE
search cm.cluster cluster-network cluster-lab cluster-ib cluster-ipmi
nameserver 127.0.0.1
nameserver 10.0.0.1
# END AUTOGENERATED SECTION -- DO NOT REMOVE
Using the GUI
Click on the cluster name in the left hand menu. This will show a number of tabs that contain cluster wide information.
On the settings tab you will find a section for name servers and another for search domains. Add the correct information and click save.
The same will then restart the named process at which point the inforation will be added to the resolv.conf file.
# This section of this file was automatically generated by cmd. Do not edit manually!
# BEGIN AUTOGENERATED SECTION -- DO NOT REMOVE
search cm.cluster cluster-network cluster-lab cluster-ib cluster-ipmi
nameserver 127.0.0.1
nameserver 10.0.0.1
# END AUTOGENERATED SECTION -- DO NOT REMOVE