Michael: Created page with "By Default Scality uses port 3080. Default Username / Password is root / admin == Ring Set Up == Log in the Supervisor Web interface Click Local and enter a Name for ..."

2013-08-14T13:45:56Z

Created page with "*By Default Scality uses port 3080. * Default Username / Password is root / admin == Ring Set Up == *Log in the Supervisor Web interface * Click Local and enter a Name for ..."

New page

*By Default Scality uses port 3080.
* Default Username / Password is root / admin

== Ring Set Up ==

*Log in the Supervisor Web interface
* Click Local and enter a Name for you Ring

== Register The Nodes ==

* Click on Hardware in the top right and corner
* In the Register server form, enter the hostname, the IP address, and the sagentd port of each node server that you want to add. The default sagentd port is 7084. The form uses 8084 by default

== Provision the Nodes ==

* Click Local to go back to the home page
* Click provisioning in your ring
* Select the nodes and click Configure

Scality: Setup Ring in Supervisor - Revision history

Michael: Created page with "*By Default Scality uses port 3080. * Default Username / Password is root / admin == Ring Set Up == *Log in the Supervisor Web interface * Click Local and enter a Name for ..."

Michael: Created page with "By Default Scality uses port 3080. Default Username / Password is root / admin == Ring Set Up == Log in the Supervisor Web interface Click Local and enter a Name for ..."