Mustang: Installation of Fedora 19 Disk Image

From Define Wiki
Revision as of 17:14, 24 March 2014 by Jon (talk | contribs)
Jump to navigation Jump to search

Pre-requisites

Prior to downloading and installing the Mustang build, you will require access to the following equipment:

  • An existing Linux system, for example a laptop or desktop system
  • A USB hard disk enclosure, or a spare disk bay in a Linux system
  • A USB serial "null modem" cable (or USB serial adapter with "null modem" cable), or a serial port and a "null modem" cable

Download Fedora 19 image

Download image from: ftp://ftp.ges.redhat.com/private/jcm/apm/f19_remix/apm_f19_v4.tar.xz

Hook up Mustang board

Prior to installing Fedora, verify that the Mustang board is correctly hooked up and ready for use.

Connect serial cable

  • Attach a USB serial cable to your Linux system (or use a serial port), along with a "null modem" cable.
  • Attach the other end of the serial cable to the DB9 connector on the rear of the Mustang system.
  • Attach an Ethernet cable into the first Ethernet port on the Mustang system, which is located furthest away from the DB9 connector, atop the two USB connectors. This is the port that Linux will recognize as "eth0" when booted.

Connect to the mustang console from another system running screen

screen -S console /dev/ttyS0 115200

Power Mustang board on

Attach the power cable to the Mustang board.

Extract Mustang Build

Once you have downloaded the Mustang build, you will need to extract the archive file. Use the following command from a Linux system: 

tar xvfJ apm_f19_v4.tar.xz

This will extract the following files: 

apm_f19_v4.img.xz
config_jcm15
mustang_linux_src_1.08.12-beta_rc.tar.xz

The first file is a compressed disk image that will be written to the hard disk installed within the Mustang board case. The other two files contain the Linux kernel configuration and source (should you - optionally - wish to rebuild the kernel that ships within this image).

Extract the disk image: 

xz -dk apm_f19_v4.img.xz

This will extract the following files: 

apm_f19_v4.img

Copy the disk image to the Mustang board

The Mustang board ships in a case containing a 500GB hard disk. Carefully remove this disk drive from the case. Then install it into either a removable USB enclosure, or into a spare disk bay within your Linux system. Linux should detect this drive and assign a name, such as "/dev/sdc". You can determine the name using the "dmesg" or (preferably) "lsblk" commands.

Copy the disk image onto the hard disk: 

dd if=apm_f19_v4.img of=/dev/sdX bs=1M

Replace "/dev/sdX" with the name of the device, for example "/dev/sdc".

Once this operation has completed, ensure that the drive is ejected safely from your Linux system: 

sync
eject /dev/sdX
Retrieved from "http://wiki.define-technology.com/mediawiki-1.35.0/index.php?title=Mustang:_Installation_of_Fedora_19_Disk_Image&oldid=4157"